Lynx Plus Series Installation and Setup Guide
- 37 -
Data Field Descriptions
93
9393
93
FLEXBLE
FLEXBLE FLEXBLE
FLEXBLE
CALLBACK
CALLBACKCALLBACK
CALLBACK
Flexible Callback
Note: This feature only applies to telephone downloading
If enabled, the control will ignore the last 1, 2, or 3 digits of the programmed callback
number (field ✻94) during a single download session. This allows the download operator
to temporarily change the callback phone number by the number of digits selected,
which allows the control to call back similar, but different numbers during a single
session. For example, if downloading to a large number of controls, the operator can
command the controls to call back phone numbers 555-1111, 555-1112, 555-1113, etc.,
thus spreading the communications among several computers.
SELECTIONS
0 = no flexible callback
1 = last digit flexible
2 = last 2 digits flexible
3 = last 3 digits flexible
DOWNLOAD INFORMATION (✻94, ✻95)
94
9494
94
DOWNLOAD
DOWNLOAD DOWNLOAD
DOWNLOAD
PHONE
PHONE PHONE
PHONE #
Download Call Back Phone Number
This is the phone number the control will use to call back the downloading computer.
Do not fill unused spaces. End field by pressing ✻. To clear entries from field, press
✻94✻.
SELECTIONS
Enter up to 20 digits as follows: 0–9, # +11 for “*”, # + 12 for “#”, # + 13 for a pause.
95
9595
95
RING
RING RING
RING
DET
DETDET
DET
C
CC
COU
OUOU
OUNT
NTNT
NT
Ring Detection Count for Downloading/Remote Phone Control Mode
Enter “15” to select defeat answering machine mode. If an answering machine is on the
premises, you need to dial the premises and hang up on the first ring. Wait at least five
(5) seconds (but no more than 22 seconds) and dial the premises phone number again.
The control will pick up and announce “SYSTEM ENTER CODE” every three seconds.
Note: To enter a number higher than 9 you must first press the [#] key.
SELECTIONS
0 = disable station initiated download and remote phone
1-14 = number of rings before control picks up phone line
15 = defeat answering machine