Honeywell LYNX Touch Series User Manual

LYNX Touch Installation and Setup Guide
- 42 -
Programming the Control
SCREEN ACTION
Quick Arm
Yes
Select “Quick Arm”. The System toggles between Yes and No.
Quick Exit
Yes
Select “Quick Exit”. The System toggles between Yes and No.
Restart Exit Time
Yes
Select “Restart Exit Time”. The System toggles between Yes and No.
SIA: The LYNX Touch default is “Yes”.
Force Bypass
No
Select “Force Bypass”. The System toggles between Yes and No.
UL installations: must be NO (no forced bypass)
Exit Warning
Yes
Select “Exit Warning”. The System toggles between Yes and No.
SIA: The LYNX Touch default is “Yes” and is not selectable.
Auto Stay Arming
Yes
Select “Auto Stay Arming”. The System toggles between Yes and No.
SIA: The LYNX Touch default is “Yes”.
Lack of Usage Notify
Disabled
Select “Lack of Usage Notify”. The System scrolls between the following options:
Disabled
1 Day
7 Days
27 Days
90 Days
180 Days
365 Days
Power-Up In Previous
Yes
Select “Power-Up In Previous”. The System toggles between Yes and No.
Note: If the previous state was Armed Away or Stay, the system will not respond to sensor changes for
1 minute. This allows time for sensors such as PIRs to stabilize.
UL installations: must be Yes (power up in previous state)
SIA: The LYNX Touch default is “Yes” and is not selectable.
Display Alarm Cancel
Yes
Select “Display Alarm Cancel”. The System toggles between Yes and No.
Display Exit Time
Yes
Select “Display Exit Time”. The System toggles between Yes and No.
Cross Zone Delay
None
Select “Cross Zone Delay”. The System toggles between the following:
None
30 Seconds
1 Minute
90 Seconds
2 Minutes
3 Minutes
4 Minutes
Note: Cross zoning can not be used in conjunction with APL.
Cross Zone 1
Disabled
Select “Cross Zone 1”. The System toggles between the following:
Disabled
Note: If Cross Zone Delay is enabled the system will display the zones that are programmed with the
following Zone Types: Day/Night, Interior Follower and perimeter.
Cross Zone 2
Disabled
Select “Cross Zone 2”. The System toggles between the following:
Disabled
Note: If Cross Zone Delay is enabled the system will display the zones that are programmed with the
following Zone Types: Day/Night, Interior Follower and perimeter.

Honeywell LYNX Touch Series Specifications

General

Zones	Up to 64 wireless zones
Integrated Camera	No
Voice Prompts	Yes
Encryption	Yes
Communication	Wi-Fi, Cellular
Backup Battery	Yes
Alarm Notifications	Yes
Siren	Built-in siren
Remote Access	Yes
Display	Color touchscreen