www.honeywellsafety.com page 17 of 24
E Maintenance
E1. A fall arrester which has arrested a person's fall from a height must
not be used again until
a
competent person has agreed
on its
further
use.
If no
competent person
is
available,
the fall
arrester must
be
returned
to the manufacturer or
authorized dealer
for
inspection
together with these
instructions
.
E2. Depending on use requirements and operational conditions, the fall
arrester must be
inspected
by a
competent person
for
unimpaired
condition
to
ensure
it is in
perfect working condition
as required, but at
least once a year. For reasons of safety the fall arrester may only be
repaired
by the
manufacturer.
Competent person is
a:
person who
due to his
training
and
experience
in the
field
of
personal
protective
equipment against falls from height has sufficient
knowledge about applicable state and local
safety
regulations,
applicable standards (e.g. EN-standards) and
is
thus capable and thus
authorized by Söll of judging the correct status and use of systems
and products against falls from
height.
E3.
Warning!
The gap between the slider (2) and the shuttle casing must not be
more than 6 mm. If this
value
is
exceeded,
the fall
arrester must
be
sent
back
to the
manufacturer
for revision.
Fig. E1
To Next Page
Loading...
