Need help?Do you have a question about the Honeywell RG500 and is the answer not in the manual?
Details of components for Part A of the RG500 Rope Grab.
Details of components for Part B of the RG500 Rope Grab.
General introduction to the RG500 Auto/Manual Rope Grab and safety.
Honeywell Fall Protection contact information and website.
Requirements and importance of user training for the PPE.
Details the standards and regulations the RG500 complies with.
Guidelines for safe transport and storage to ensure longevity and safety.
Instructions for cleaning the RG500 Rope Grab to maintain its performance.
Pre-use inspection checklist and safety precautions.
General instructions on how to use the RG500 Auto/Manual Rope Grab.
Use of RG500 as a guided type fall arrester per EN 353-2:2002.
Using RG500 as a safety line adjustment device per EN 12841/A:2006.
Using RG500 as a temporary flexible anchor point per EN 795/B:2012.
Guidelines for using RG500 for rescue operations.
How to correctly connect the RG500 to a fall arrest harness.
Instructions for installing the flexible anchor line to the RG500.
Requirements for selecting a safe anchorage point.
Specific considerations for using the RG500 horizontally.
Required minimum vertical clearance for safe operation.
Details about the provided flexible anchor line and its use.
Requirements and schedule for periodic inspection of the PPE.
Information on the expected lifespan and factors affecting it.
Introduction and specifications of the RFID tag feature.
Overview of the RFID tag for asset tracking and inspection.
Technical details of the RFID tag, including frequency and protocol.
Information on products tagged with RFID or barcode.
How to use the RFID tag with Safety Suite software.
Advice on scanning the RFID tag after cleaning the PPE.
Guidance on proper disposal of the product according to WEEE.
General| Ingress Protection | IP66 |
|---|---|
| Type | Fixed Gas Detector |
| Gas Type | Combustible gases |
| Sensor Type | Catalytic bead |
| Response Time | <30 seconds (depends on gas and sensor type) |
| Certifications | ATEX, IECEx |
| Output | 4-20 mA, HART |
| Detection Gas | Combustible Gases |
| Detection Principle | Catalytic Bead |
To Next Page