Honeywell Miller Vi-Go - B Installation

page 6 of 24 www.honeywellsafety.com
B Installation
B1. Important
Before installation, check whether the component on which the Söll
Vi-Go system is to be fixed is capable of withstanding loads resulting
from a fall (certificate for stability). A qualified engineer must certify
this.
The maximum length of the cable may not exceed 200 m.
The following characteristic loads form the basis of the certificate of
stability: loads resulting from dynamic loads due to fall, user loads
and the individual weight of the system components.
For fastening the upper end of the cable, acting vertically downward:
number of
simultaneous users
Characteristic vertical
load Fc1 [kN]
2
9,0
3
10,0
4
11,0
5
12,0
6
13,0
7
14,0
8
15,0
For fastening the intermediate bracket and the lower end of the
cable, independent of the number of users, effective in each
direction: Fc2 = 1.5 kN