ML7999A UNIVERSAL PARALLEL-POSITIONING ACTUATOR
65-0239—2 6
8. If the device shaft turns, reconnect the actuator and
wiring and drive the actuator hub clockwise and
counterclockwise. If the actuator does not drive, replace
the actuator.
9. If the actuator and device shaft turn freely, remount the
actuator to the device according to instructions in the
Installation section. Make sure the actuator does not
bind and that the actuator and device are both at the
same clockwise or counterclockwise end stop when
assembled. Hook up the wires and repeat the Checkout
procedures. Troubleshoot if necessary.
To Next Page
Loading...
