Honeywell MM14 Series User Manual

EN
To install the window bracket to the
window frame, you need to adjust the
height or width of the window bracket by
extending the length according to the
height or width of the window or balcony
door. When the length is set, tighten the
butterfly screws (preinstalled on the
window bracket) to ensure the window
bracket is secured in the desired position.
Use one or all three pieces of window
bracket as needed.
1. Install the plastic hose with window bracket adapter and hose connector on both sides. Ensure
proper fit on both ends.
2. The Window Brackets are approximatley 72 cm / 28.3 inches each, allowing you to install to
windows and balcony doors of different heights or width.
INSTALLATION
1.
2.
3.
4.
Window Bracket Kit.............................
Window Bracket Panel Adapter...........
Hose Connector..................................
Plastic Hose........................................
3
Installation Kit:
Installation Steps:
1 Set
1 Piece
1 Piece
1 Piece
3.
4. Connect the window bracket to the opposite
end of the plastic hose. Ensure that all
connections are tight and installed properly.
5. Connect the window bracket to the window.
6. The Portable Air Conditioner is now ready to
use.
28.3”
72 cm
1 part
72 cm / 28.3” to
135 cm / 53.1”
2 parts
2 m / 78.7”
3 parts
Butterfly Screws
Connect the plastic hose to the rear exhaust
outlet on the back of the unit. Push-in until it is
locked in place.
1
x 1
4
x 1
2
x 1
x 1
3

Honeywell MM14 Series Specifications

General

Brand	Honeywell
Model	MM14 Series
Category	Air Conditioner
Language	English