MPD Operating Manual
7
» When using a linear cross reference factor the temperature compensation is based
upon propane, and there may be errors at temperatures away from the calibration
temperature.
» To maintain safety standards, regular maintenance, calibration and operation of the
equipment by qualified personnel is essential.
» Do not modify or alter the sensor construction as essential safety requirements
may be invalidated.
» When replacing sensors, dispose of used sensors in accordance with local
disposal regulations. For more information on sensor disposal, contact your HA
Representative.
ATEX Temperature Code Ratings
» Component gets no hotter than an operating temperature code of T4 when installed
according to the electrical specifications of Label ( Sch Drawing 1226E0309)
» Maximum surface temperatures is less than 85°C when measured under normal
operating conditions for the Dust evaluation.
Important Notices
Every effort has been made to ensure the accuracy of the contents of our documents,
however, Honeywell Analytics can assume no responsibility for any errors or omissions in
our documents, or their consequences.
Honeywell Analytics can take no responsibility for installation and/or use of its equipment if
this is not done in accordance with the appropriate issue and/or amendment of the manual.
The user of this manual should ensure that it is appropriate in all details to the exact equipment
to be installed and/or operated. If in doubt, the user should contact Honeywell Analytics for
advice.
If further details are required which do not appear in this manual, contact Honeywell Analytics
or one of their agents.
To Next Page
Loading...
Need help?
General
