Honeywell Multisite XIO Series User Manual

MOUNTING AND WIRING INSTRUCTIONS
31-00360-01
XIO Family of Spectrum System
Remote Input/Output Devices
INTRODUCTION
The SpectrumXIO family of devices are intended to be
replacement devices for the original Novar Legacy
Spectrum Rack Input and Output modules that have been
previously installed. These modules include the following
modules: Rack Input Module, Rack Output Module,
Compressor Output Module, Condenser Control module,
Analog Output Module, Case Input Module 2, and 8-Input
Module.
Fig. 1. XIO Output device with HOA switches.
Fig. 2. XIO family of Spectrum System Remote I/O (for reference only).
Contents
Introduction .................................................................................. 1
Specifications ............................................................................... 3
Mounting ........................................................................................ 4
Wiring .............................................................................................. 5
Spectrum Network Wiring ....................................................... 8
Setting MAC Address and Mode Select Switches .......... 8
Model and Part Numbers ........................................................ 10
Regulatory Compliance ............................................................ 16

Honeywell Multisite XIO Series Specifications

General

Category	I/O Systems
Manufacturer	Honeywell
Input Voltage Range	24 VDC
Enclosure Rating	IP20
Communication Protocol	Modbus TCP/IP

Summary

Introduction to XIO Devices

Specifications

Physical Dimensions

Details physical dimensions for specific XIO models.

Mounting

Din Rail Mounting

Instructions for mounting the device onto a DIN rail.

Din Rail Un-Mounting

Steps to safely remove the device from a DIN rail.

Panel Mounting

Instructions for mounting the device onto a panel.

Wiring

Terminal Label/PIN Configuration

Shows terminal pinouts for various XIO models.

Wiring Method

Details the methods and wire gauges for making connections.

Spectrum Network Wiring

Setting MAC Address and Mode Select Switches

DIP Switch Configuration

Instructions for configuring MAC address and device options using DIP switches.

Timeout Value

Model and Part Numbers

Maintenance and Replacement Context

Explains XIO modules as replacements for Novar systems, including compatibility and limitations.

Legacy Module Replacement Comparisons

ROM Module Replacement

Compares Novar Spectrum ROM module with XIO-ROM-S for replacement.

COM Module Replacement

Compares Novar Spectrum COM module with XIO-COM-S-H for replacement.

CCM Module Replacement

Compares Novar Spectrum CCM module with XIO-CCM-S-H for replacement.

AOM Module Replacement

Compares Novar Spectrum AOM module with XIO-AOM-S for replacement.

CIM2 Module Replacement

Compares Novar Spectrum CIM2 module with XIO-CIM-S for replacement.

8IMR/8IME Module Replacement

Compares Novar Spectrum 8IMR/8IME module with XIO-8IM-S for replacement.

RIM Module Replacement

Compares Novar Spectrum RIM module with XIO-RIM-S/RIMCT for replacement.

Regulatory Compliance

Canadian Department of Comms (DOC)

Details compliance with Canadian interference-causing equipment regulations.

WEEE Directive Compliance

Information on waste disposal of electrical and electronic equipment according to WEEE directive.

Conformité Européenne (CE)

Details European conformity for EMC and LVD requirements.