ActiveSync using USB-Client Connection
The only connection type is USB Client.
1. Connect the MX7 Tecton end of the USB cable
to the I/O port on the bottom of the MX7 Tecton.
2. Connect the USB type A connector on the I/O
cable to a USB port on a PC or laptop.
ActiveSync starts automatically when the USB cable is
connected.
When the MX7 Tecton loses connection (e.g., enters
Suspend Mode), the connection to ActiveSync will be
temporarily lost. When the MX7 Tecton resumes, the
ActiveSync session will automatically re-connect.
Please refer to the MX7 Tecton Reference Guide for
ActiveSync information.
To Next Page
Loading...
