Honeywell Voyager MS9520

To Next Page

How to install the Honeywell (formerly Metrologic) Voyager Scanner

This article covers the steps required to install the Voyager wand scanner for use with the Web

Kiosk or Point of Sale (POS) terminal within the ClubReady system

Requirements:

1. Admin rights on the computer you are installing the scanner on

2. An availible USB port on the computer or powered USB Hub.

3. Access to the notepad application on your computer to test the scanner after install.

Step 1 - Verifying you have the correct scanner

Please verify the scanner matched the information listed below. If anything does not match

these instructions will not work for installing your scanner. This may also mean ClubReady will

not support or only be able to provide limited support for your scanner.

Manufacturer: Honeywell (formerly Metrologic)

Model Name: Voyager

Model Number: MS9520

Part Number: MK9520-32A38

Once you have verified all of the information above is correct, please continue to the next step.

How to install the Honeywell (formerly Metrologic) Voyager Scanner - 1

Need help?

Do you have a question about the Honeywell Voyager MS9520 and is the answer not in the manual?

Honeywell Voyager MS9520 Specifications

General

Scan Pattern	Single line
Light Source	650 nm visible laser diode
Humidity	5% to 95% relative humidity, non-condensing
Decode Capability	Reads standard 1D and GS1 DataBar symbologies
Input Voltage	5 VDC ± 0.25 V
Connectivity	USB, RS-232, Keyboard Wedge
Dimensions	198 mm x 78 mm x 56 mm
Weight	149 g
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 60°C
Light Levels	4842 Lux
Drop Resistance	Designed to withstand 1.5 m drops
Interface	USB, RS-232, Keyboard Wedge, IBM 468X/469X, Wand Emulation
Cable Length	2.1 m straight
Drop Specification	Withstands multiple 1.5 m drops to concrete