Need help?Do you have a question about the Honeywell Notifier NFN-GW-EM-3 and is the answer not in the manual?
General| Model | NFN-GW-EM-3 |
|---|---|
| Category | Gateway |
| Manufacturer | Honeywell Notifier |
| Power Supply | 24 VDC |
| Humidity Range | 10% to 93% non-condensing |
| Communication Protocols | Ethernet |
| Network Interface | 10/100 Mbps Ethernet |
| Operating Temperature | 0°C to 49°C (32°F to 120°F) |
Explains the role of a redundant gateway for network communication backup.
Lists required IP ports (53, 80, 123, 443, 2017, 4016, 5000, 5100) for NFN-GW-EM-3 functionality.
Details typical and maximum bandwidth requirements for typical and audio data.
Lists restrictions including static IP, no DHCP, no NAT, and no HTTP Proxy.
Details compliance with NFPA, UL, and ULC standards for fire alarm systems.
Specifies limitations on shared equipment and web portal usage.
Identifies and describes the various connectors on the NFN-GW-EM-3 board.
Explains how to supervise the NFN-GW-EM-3 using an input module on an FACP.
Illustrates routing power and communication to a standard NCM.
Shows how to route power and communication to a High-Speed NCM.
Details connecting the NFN-GW-EM-3 to a Fire Alarm Control Panel via NUP.
Describes connecting the NFN-GW-EM-3 to the PNET-1 surge suppressor.
Provides step-by-step instructions for accessing the NFN-GW-EM-3 web page.
Illustrates the layout of the gateway's configuration tool interface.
Describes the options available within the configuration tool's main menus.
Details how to view product type, brand, version, and board information.
Covers configuring IP settings, monitored clients, and gateway properties.
Explains how to view information about connected nodes in the configuration tool.
Defines labels and describes how to view error messages related to web portal connections.
To Next Page