Need help?Do you have a question about the Honeywell Notifier MODBUS-GW and is the answer not in the manual?
General| Model | MODBUS-GW |
|---|---|
| Type | Gateway |
| Communication Protocol | MODBUS RTU |
| Communication Ports | RS-485 |
| Data Bits | 8 |
| Parity | None, Even, Odd |
| Stop Bits | 1, 2 |
| Power Supply | 24 VDC |
| Description | Gateway for integrating Notifier fire systems with MODBUS networks |
| Baud Rate | 9600, 19200, 38400, 57600, 115200 bps |
| Operating Temperature | 0°C to 49°C |
Highlights essential security practices to protect the system.
Outlines IP address, port, and network configuration needs.
Lists all components and equipment needed for installation.
Details procedures for physically installing the MODBUS-GW board.
Provides information on connecting the MODBUS-GW.
Explains how to connect the MODBUS-GW board to various components.
Outlines procedures for testing and maintaining the system.
Describes accessing the MODBUS-GW via a web page.
Provides steps for configuring the MODBUS-GW.
Guides the user on how to log into the gateway's web interface.
Details additional configuration settings for the gateway.
Explains how the gateway synchronizes with panels for reliable data.
Details the Modbus addressing scheme used by the gateway.
Covers reading and trending analog values from 4-20mA modules.
Details the bit definitions and addresses for point status registers.
Explains registers for point device types and their addresses.
Covers status registers for zones and panel circuits.
Lists input registers for analog values from 4-20mA modules.
Details input registers for panel and system trouble information.
Provides basic guidelines for installing the MODBUS-GW.
To Next Page