22 MODBUS-GW Installation and Operation Manual — P/N LS10015-000NF-E:C2 4/30/2019
Section 3 Configuration
3.1 Configuration Web Page
Configuration of the MODBUS-GW is through a web page running on the MODBUS-GW. Supported web browsers are listed in 1.4,
"Required Software".
The following information applies to IP settings:
• Each MODBUS-GW is shipped with a default IP address of 192.168.1.2 and a default node number of 240.
• The computer used to configure the MODBUS-GW must be able to establish an IP connection to the gateway. Consult with a
network administrator if unsure how to make this connection.
• Connecting more than one MODBUS-GW prior to reconfiguring the IP address will result in an IP address conflict.
•Refer to Appendix A, "Gateway Settings" for instructions on resetting and reviewing the IP settings of the MODBUS-GW.
3.2 Configuring the MODBUS-GW
3.2.1 Logging into the Web Page
Log into the MODBUS-GW as follows:
1. Start the web browser.
2. Navigate to the IP address of the gateway (default http://192.168.1.2).
3. If a security warning appears, select the option to continue anyway. Refer to 3.3, "Security Certificate" for more information.
4. Log into the web page:
a. If the password has already been established, enter the password and click OK.
b. If any of the following conditions is true, go to Step 5:
• A new gateway from the factory.
• An upgrade of a gateway from a previous version for which the password has not been set (i.e. still using
the default password).
• After a factory reset of the gateway.
5. To set a new password:
a. Enter the default password, 00000000 (eight zeros) and click OK. The Set Device Password dialog box
appears.
b. Reenter the default password.
c. Enter a new password.
d. Reenter the new password to confirm.
e. Click OK.
To Next Page
Loading...
Need help?
General