Honeywell Notifier NFN-GW-EM-3 User Manual

14 NFN-GW-EM-3 Installation and Operation Manual — P/N LS10017-000NF-E:D1 5/1/2019
Section 2 Installation
2.1 Required Equipment
2.1.1 NFN-GW-EM-3 Assembly:
The following components are shipped with the NFN-GW-EM-3:
• NFN-GW-EM-3 Printed Circuit Board
• Surge Suppressor (P/N PNET-1)
• NUP-to-NUP Cable (P/N 75577) - Used to connect the NFN-GW-EM-3 board to an NCM-W or NCM-F board or supported
panel.
• Wire Leads-to-NUP Cable (P/N 75583) - Used to connect 24V power from the NFN-GW-EM-3 board to an NCM-W or NCM-F
board.
• USB Cable (P/N 75665) - Used to connect the NFN-GW-EM-3 board to an HS-NCM board:
2.1.2 Network Components:
• High-speed Network Communication Module (HS-NCM) - Used to facilitate network communication between the
NFN-GW-EM-3 and a High-Speed NFN network (sold separately)
OR
• Network Communication Module (NCM) - Used to facilitate network communication between the NFN-GW-EM-3 and an NFN
network (sold separately)
OR
• Compatible FACP with NUP Port
2.1.3 Customer Supplied Equipment:
• Computer - Used to run a web browser to configure the NFN-GW-EM-3. Refer to 1.4, "Required Software" for recommended
browsers.
• Ethernet Patch Cable - Used for connecting the NFN-GW-EM-3 to Local Area Network (LAN).
–HS-NCM-W –HS-NCM-MF
–HS-NCM-WMF –HS-NCM-SF
– HS-NCM-WSF – HS-NCM-MFSF

Honeywell Notifier NFN-GW-EM-3 Specifications

General

Brand	Honeywell
Model	Notifier NFN-GW-EM-3
Category	Gateway
Language	English