Accenta/Optima User Guide
3
How to Unset the System
When you enter your premises you will need to unset (turn off) the system.
LCD Keypad:
• Enter the premises by the agreed entry route. Thesystem
produces an entry tone. The Power LED is on and the Day
LED is off indicating that the system is set.
• Enter your 4-digit code (0123 default).
• The system unsets with a double beep. The Day LED
comes on indicating that the system is unset.
• After 30 seconds the Day mode display appears.
SundaySunday
SundaySunday
Sunday
01-Jan01-Jan
01-Jan01-Jan
01-Jan
14:10 14:10
14:10 14:10
14:10
[4-digit code]
SundaySunday
SundaySunday
Sunday
01-Jan01-Jan
01-Jan01-Jan
01-Jan
14:10 14:10
14:10 14:10
14:10
** SYSTEM UNSET **** SYSTEM UNSET **
** SYSTEM UNSET **** SYSTEM UNSET **
** SYSTEM UNSET **
LED Keypad:
• Enter the premises by the agreed entry route. Thesystem
produces an entry tone. The Power LED is on and the
Day LED is off indicating that the system is set.
• Enter your 4-digit code (0123 default).
• The system unsets with a double beep. The Day LED
comes on indicating that the system is unset.
TA
PA
Day
Power
TA
PA
Day
Power
[4-digit code]
If any Zone, TA (Tamper) or PA (Attack) LED’s come on then an alarm has occurred, and an intrusion may
have taken place. Seek assistance before investigating further as intruders may still be on the premises. Then
reset the system.
When you enter your premises you will have a short period of time, usually 30 seconds, to enter your code. If
you fail to do this the system will go into alarm. Enter your code to stop the alarm.
How to Unset the System
To Next Page
Loading...
Need help?
General
