2 PW7K Security Manual @Honeywell Inc
Securing Fieldbus Wiring
The PW7K support below types of field bus protocols over three wire and RS-485
physical cables.
Cables used for Wiegand and SIO communications must be concealed in the
secured area and must not be freely accessible.
Securing The Enclosure
Install the hardware in the secure enclosure with tamper protection to generate
notifications when the enclosure is opened/tampered. It is recommended to
mount SIO in the same enclosure as controller board.
Ensuring The Latest Firmware
Always make sure to check for the new releases of the PW7K & SIO Interface board
firmware and update panel to use latest version of the firmware. This ensures the
latest changes and security improvements are installed.
Normal Operations
Set all DIP switches to OFF for normal Operation.
Caution: The PW7K panel is not recommended to connect to any
untrusted network, Internet. The PW7K panel in is designed to
work in trusted or protected network where known users can
interact with the panel. If the panel is connected to the
INTERNET, remote attacker may try to exploit or damage the
panel.
Note: The user will own the risk, if the user connects the panel to
the Internet or any untrusted network
Protocol Medium Purpose Preferred Cable
Wiegand
Three wire bus Reader communication CAT 6E/FSTP
OSDP
RS-485 Reader communication CAT 6E/FSTP
SIO
RS-485 SIO Module communication CAT6E/FSTP
To Next Page
Loading...
