PW7K Security Manual @Honeywell Inc 9
Data at Rest Encryption
The PW7K panel comes with the option of “Enable Encryption Partition” to protect
cryptographic keys and satisfy privacy concerns for end users in the field. The
encryption will allow the configuration and data files to be stored in encrypted for-
mat. It is recommended to always select “Enable Encryption Partition” option
before leaving panel in normal operation.
Network Ports
Physical Ports, Protocols, and Services
The following inbound ports are used to accept the connections:
PW7K Panel Inbound Ports.
Equipment Replacement/Decommissioning
When replacement/decommissioning a board, make sure to use factory default
option to clear all data in the controller before discard panel. Please refer to the
PW7K Installation Guide for detailed step by step instructions to put the panel in
the factory default condition.
Port Protocol Standard/Custom Disable
67
UDP DHCPS Used for DHCP
68
UDP DHCPC Used for DHCP
80
TCP HTTP Yes – Use Disable Web Server from the
Users web confirmation page
443
TCP HTTPs Yes - Use Disable Web Server from the
Users web configuration page.
161
UDP SNMP Yes – Use Disable SNMP from the
Users web configuration page.
3001
TCP Mercury Host
Protocol(MSP2)
Yes – Set the Connection Type from the
Host Comm page to an option other than
IP.
Note: For the best security it is
recommended to change default host
communication port.
5353
UDP Zeroconf (Discovery
service)
Yes – Use the Disable Bonjour option
from the Users web configuration page.
To Next Page
Loading...
