Honeywell PRO3200 - Document Confidentiality

Installing the PRO3200 Two-Reader Module
Setup
PRO3200 Two-Reader Module Installation Guide, Document 800-15493 3
Setup
Setting Jumpers
Table 1: Jumper Settings
Jumper Setting Default Selected
J1 OFF * Port 1 RS-485 EOL
terminator is not active
ON Port 1 RS-485 EOL
terminator is active
J2 OFF Reader 0 Power Terminal
provides 5 VDC
ON * Reader 0 Power Terminal
provides 12 VDC
J3 OFF Reader 1 Power Terminal
provides 5 VDC
ON * Reader 1 Power Terminal
provides 12 VDC