86 PX4ie and PX6ie High Performance Printer User Guide
Adjusting the Printer
You may need to adjust your printer to accommodate your printing needs or
improve performance. The following can be adjusted:
•pressure arm
• label stop sensor (LSS) position
• printhead pressure
• label taken sensor
Adjusting the Pressure Arm
The printer is factory-adjusted for full-size media width. If you are using media that
is less than full width, adjust the position of the pressure arm so that it is centered
on the media and provides even pressure.
A poorly adjusted pressure arm may be detected by a weaker printout on either side
of the media path.
To adjust the pressure arm
1. Turn off the printer.
2. Open the front door and media cover.
3. If necessary, remove the ribbon.
To Next Page
Loading...
