Honeywell RTH5100B - Page 23

23 69-1716
10. Configure Installer Setup (Cont)
4. Press the Up or Down button to select your setting
for Installer Setup Number 1 in the table below.
5. After you select your setting, press the Next button
to go to the next Installer Setup Number.
Replace Batt
Se
rvi
ce
N
eeded
D
o
n
e
N
e
x
t
M22122
SETTING
IN
S
TALLER
S
ET
UP
NUMBER
1 Heating
and/or
Cooling
System
Type
Gas, oil or
electric heating with central air
conditioning.
The compressor
outside runs in both heating and
cooling.
Gas, oil or electric
heating without central air
conditioning.
Gas, oil
or electric heating without central air
conditioning. (Use this setting if you
could turn the fan on and off with a
fan switch on your old thermostat.)
DOWN BUTTON
NEXT BUTTON
UP BUTTON