Honeywell RTH5100B - Page 24

69-1716 24
Configure Installer Setup (Cont)
6. If you do not have a number 2 on the left side of
your display, go to the next page.
7. If you have a number 2 on the left side of your
display, press the Up or Down button to select your
setting for Installer Setup Number 2 in table below.
8. After you select your setting, press the Next button
to go the next Installer Setup Number.
Replace Batt
Se
rvi
ce
N
eeded
D
o
n
e
N
e
x
t
M22060
SETTING
IN
S
TALLER
S
ET
UP
NUMBER
2 Heat
Pump
Change-
over
Valve
Use this setting if you connected a
wire labeled O to O/B W terminal.
Use this setting if you connected a
wire labeled B to O/B W terminal.
DOWN BUTTON
NEXT BUTTON
UP BUTTON