Honeywell RTH8500D - Page 16

69-1725-1 16
Step 7. Connect Wires to New Wallplate (Cont)
5. Loosen the screw terminals. Insert the labeled wires into the
holes on the side of the terminal block that match the letter
designations. Tighten the screw terminals.
6. If any of the labeled wires do not match the letter designations,
see next page for wire connections.
M22207
LABELED WIRES
C (NOT USED)
G
W
R
RC
SCREW TERMINALS
TERMINAL BLOCK
LETTER
DESIGNATIONS
Y
INSERT WIRE IN HOLE
WIRE HOLE
RC
W
R
G
WALLPLATE
Y