SPYDER MODEL 5 ROOM CONTROLLERS − INSTALLATION GUIDE
31-00281ES-01 (EN1B-0664GE51 R0819) 14
controller's effective occupancy mode. Specifically, the
following modes are supported:
▪ UNOCCUPIED: If the wall module's LED is OFF, then the
controller is in the "unoccupied" mode.
▪ STANDBY: If the wall module's LED flashes once per sec,
then the controller has received a network command
and been placed in the "standby" mode.
▪ OCCUPIED: If the wall module's LED is ON, then the
controller is in the "occupied" mode.
▪ BYPASS: If the wall module's LED is ON continuously,
then the controller has received a network command
and been placed in the "bypass" mode.
▪ HOLIDAY: If the wall module's LED is OFF, then the
controller has received a network command and been
placed in the "holiday" mode.
LCD of TR42x Programmed to Display Info on
Occupancy
The LCD of TR42x connected to the controller can be
programmed to display various texts and symbols to
indicate the effective occupancy mode of the controller.
The following then applies.
To Next Page
Loading...
Need help?
General
