15
Optimisation
Your Thermostat has optimisation functions that aim to save energy while maintaining
suitable comfort levels. The Thermostat displays during the optimisation period if set. By
default optimisation is disabled, see instructions on installation guide on how to activate it.
• Optimum Start learns how long it takes your home to reach a set temperature and then
turns the heating on a bit earlier to achieve that temperature at the programmed time.
• Delayed Start saves energy by slightly delaying the start of heating depending
on the difference between the set temperature and the room temperature.
The closer these temperatures are the longer it will delay the start.
• Optimum Stop saves energy by switching off a little bit earlier than the
programmed time. If your home is up to temperature, you will not notice the
effect on the temperature, but you should see a difference in your fuel bill.
Optimisation
5
To Next Page
Loading...
Need help?
General
