EasyManuals Logo

Honeywell T7200 Owner's Manual

Honeywell T7200
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
U
KEYS USED FOR THE SETPOINT ADJUST OVERRIDE
SETPOINT ADJUST
This override is useful in situations where the occupied
space feels too cool or warm for the occupants and a
temporary change of setpoint would make the temperature
more comfortable. It can be called from either the Occu-
pied or Unoccupied modes and functions in this way:
-
Press the 3 HOUR OCCUPIED key. If in Unoccupied.
the thermostat will go to the Occupied mode, controlling
the space temperature to the Occupied setpoints for 3
hours. If in Occupied mode, no change of setpoints will
occur. However, this will ensure 3 hours of Occupied set-
point control regardless of any Unoccupied Start Times
that may be programmed. The indicator on the left side of
the display will point to 3 HR OCCUPIED while this over-
ride is in effect.
THEN:
-
Press the the + key. This will adjust the setpoint up by
a preprogrammed “Amount of Setpoint Adjust”. As an
example, Occupied Heat is set for 70 F and “Amount of
Setpoint Adjust” is set for 5 F. After the + key is pressed,
the Occupied Heat setpoint will be 70 + 5 or 75 F. The
thermostat will then control the space temperature to 75 F
and the indicator on the left side of the display will
continue to point to 3 HR OCCUPIED during the
remainder of the 3 hours of adjusted setpoint.
OR
-
Press the
-
key. This will adjust the setpoint down by a
preprogrammed “Amount of Setpoint Adjust”. As an
example, Occupied Heat is set for 70 F and “Amount of
Setpoint Adjust” is set for 5 F. After the
-
key is pressed,
the Occupied Heat setpoint will be 70 5 or 65 F. The
thermostat will then control the space temperature to 65 F
and the indicator on the left side of the display will
continue to point to 3 HR OCCUPIED during the
remainder of the 3 hours of adjusted setpoint.
NOTE:
Refer to the section titled TO SET THE AMOUNT OF SET-
POINT ADJUST for instructions on how to vary the
setpoint
adjust.
15

Other manuals for Honeywell T7200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell T7200 and is the answer not in the manual?

Honeywell T7200 Specifications

General IconGeneral
BrandHoneywell
ModelT7200
CategoryThermostat
LanguageEnglish

Related product manuals