T7350 COMMERCIAL PROGRAMMABLE THERMOSTAT
63-2605—09 14
Use the Test Mode to check the thermostat configurations and
operation. To start the system test:
1. Press Schedule Day, Occupied and Not Occupied
simultaneously.
2. The display gives the option to TEST.
a. To enter test mode, press up ▲ or down ▼ until the
display indicates IN TEST.
b. To cancel this option, ensure the display indicates
NO TEST.
3. Press Run Schedule.
NOTES:
— To verify whether or not the system test is still
active, repeat the above process.
— The system test times out after ten minutes with no
key pressed.
Save User Schedule (Info/Copy)
Performing this operation saves the current schedule (including
holidays) to memory, overwriting the old saved schedule:
1. Press both Info and Copy.
2. The display gives the option to SAV SHD.
a. To save the current schedule, press up ▲ or
down ▼ until the display indicates YES.
b. To cancel this option, ensure display indicates NO.
3. Press Run Schedule.
Get User Schedule (Info/Run)
Getting the user schedule restores the schedule (including
holidays) from saved memory, overwriting the schedule
currently in use:
1. Press both Run Schedule and Info.
2. The display gives the option to GET SHD.
a. To retrieve the saved schedule, press up ▲ or
down ▼ until the display indicates YES.
b. To cancel this option, ensure display indicates NO.
3. Press Run Schedule.
To Next Page
Loading...
Need help?
General
