To Next Page

To Previous Page

T7350 COMMERCIAL PROGRAMMABLE THERMOSTAT

63-2605—09 18

1. To use the default occupied override, press Tem po ra r y

Occupied.

NOTE: The default temperature setting is the

Occupied setpoint.

2. To select a temperature setting other than the default,

press up ▲ or down ▼ until the desired temperature

offset is displayed (range is 0° F to 3° F [0° TO 2° C]).

NOTE: This offset can be restricted by the limits

detailed in the Setpoint Limits section.

Using Temporary Not Occupied Override

The Temporary Not Occupied Override fixes the device to

operate in Not Occupied mode for a number of days (between

1 and 99) without changing programming saved in memory.

NOTES:

— If the number of days is set to zero, no temporary

change takes effect.

— If the number of days is set just below zero, the

display for days is “---” (an indefinite override).

— To turn off this override, you must press Run

Schedule.

1. Press Temporary Not Occupied.

2. Press up ▲ or down ▼ to change the duration of the Not

Occupied period (in days).

NOTE: The default temperature setting is the

Not Occupied setpoint.

3. Press to display the default setpoint.

NOTE: The only way to change this setpoint is to

change the Not Occupied setpoint.

Honeywell T7350 User Manual

Other manuals for Honeywell T7350