T7512A,B PROGRAMMABLE LOAD MANAGEMENT THERMOSTAT
Table 2. Installer Configuration Items.
Configuration
Item Use To
Code
Displayed
Possible
Settings
What the
Setting
Means
Fan On Heat Set fan to come on immediately when the heating or
cooling equipment is energized. Set to No if this is a
conventional application.
FOH
0 No
1 Yes
Fan On
Occupied
Set fan to stay energized continuously during occupied
periods. This option has no effect on T7512 models
FOO
0 No
1 Yes
Cycles Per Hour Minimize room temperature swings by setting the
maximum on-time of the heating equipment. Set to 6
for a warm air furnace. Set to 3 for a hot water boiler
system. Set to 9 for electric heat. For conventional
heating systems only (T7512A).
CPH
3 3
6 6
9 9
Temperature
Units
Set the units where the temperature is displayed on the
thermostat: Fahrenheit (F) or Celsius(C).
TMP F F
C C
Enable Offset Allow the homeowner to enter offsets. This item should
be set to No unless the homeowner subscribes to
Time-of-Use Pricing.
EOF
0 No
1 Yes
Service Phone Display a phone number when the thermostat
communication module loses the ability to
communicate. Set this item as directed by the local
utility.
PHO
0 No
1 Yes
Flashing Call Flashes CALL message on display when the
thermostat communication modules loses the ability to
communicate. Set to Yes to enable this feature. Set to
No to disable the feature, or when using the thermostat
as a standalone device.
CAL
0 No
1 Yes
Software Version Display the software revision level
(for example, revision level 1.00 displays as 01 00).
ZZ ZZ
— —
System Type Display the thermostat changeover and system type.
XX specifies the type of changeover:
a A= Auto changeover.
BB= Manual changeover.
YY specifies the system type:
13= 1H1C power stealing, conventional.
34= 2H2C hardwired, conventional.
XX YY
5
69-1574
To Next Page
Loading...
Need help?
General
