10
69-1153
Before programming the thermostat, remove the
clear plastic overlay that covers the display.
When pressing the keys, use the ball of your
finger or a soft pencil eraser; using sharp
fingernails or pencil points can damage the
keypad. If you make a mistake during program-
ming, press the Run Program key and repro-
gram the time, temperature, or offset value with
the error.
Step 1—Set the Current Time/Day
To set the time, press and release the Set
Clock/Day key once. Press Ahead or Back
keys until the current time is displayed. To set
the day, press and release the Set Clock/Day
key again. Press Ahead or Back keys until the
current day is displayed. After you have set the
time and day, press the Run Program key.
Step 2—Enter the Program Schedules
Entering a Heating Schedule
Refer to your Personal Programming Charts and
proceed as follows:
Press the System key until the thermostat
displays the word HEAT to indicate you
are in the heating mode. Press and
release the Weekday Schedule key once.
The words WAKE, MON...FRI and SET
appear on the display.
Press the Ahead or Back keys to set the
weekday WAKE time from your Personal
Programming Charts. Press the Warmer
To Next Page
Loading...
Need help?
General
