Honeywell th511od - User Manual

Honeywell
TH5110DNon-programmable
Thermostat
APPLICATION
The TH511OD Non-programmable Thermostat provides
electronic control of 24 Vac, single-stage heating and
cooling systems or 750 mV heating systems. See Table 1
for a description.
Table 1,TH5110D Thermostat description.
Feature Description
Powering Methods • Battery only
• Common wire only
• Common wire with battery backup
System Types (Up to 1 Heat, 1 Cool) Gas, oil or electric heat with air conditioning
Warm air, hot water, high efficiency furnaces, heat pumps, steam
and gravity
Heat only-- includes power to open and power to close zone valves
(Series 20) and normally-open zone valves
Heat only with fan
Cool only
750 mV heating systems
Changeover Manual or auto changeover selectable
System Setting Heat-Off-Cool-Auto
Fan Setting Auto-On
MERCURYNOTICE
tf this control is replacing a control that contains
mercury in a sealed tube, do not place your old
control in the trash.
Contact your local waste management authority
for instructions regarding recycling and the
proper disposal of the old thermostat.
¢_)U.S. Registered Trademark
Copyright © 2004 Honeywell International inc. ° _ • AN Rights Reserved 69-171211

Honeywell th511od Specifications