VISIONPRO
®
8000 WITH REDLINK™
7 68-0312—01
INSTALLATION OPTIONS
The VisionPRO® 8000 with RedLINK™ system can be wired directly to the equipment, used with an Equipment Interface Module,
or with a TrueZONE wireless adapter.
If using the Equipment Interface Module, see “Installing Equipment Interface Module (if used)” on page 8.
If using a TrueZONE wireless adapter, follow the installation instructions that came with the TrueZONE panel, and go to “Selecting
Thermostat Location” beginning on page 10.
Fig. 5. VisionPRO® 8000 with RedLINK™ installation options.
* The relay outputs and inputs on the thermostat do not function when used with an Equipment Interface Module or the TrueZONE
Wireless Adapter.
* If the thermostat has been setup WITHOUT an Equipment Interface Module or the TrueZONE Wireless Adapter and you would
like to add one, you must reset the thermostat back to factory defaults. Press MENU > Installer Options > scroll down to select
Reset to Defaults.
Model Numbering TH8321 TH8320 TH8110
Stages 3H/2C HP
2H/2C CONV
3H/2C HP
2H/2C CONV
1H/1C HP
1H/1C CONV
Residential or Commercial 333
Dual Powered - C Wire or Battery 333
Onboard Humidity Sensor 3
Number of Universal Relays 1 0 0
Number of Universal Sensor Inputs 1 1 1
Economizer / TOD Output 33
Works with Optional Equipment Interface Module* 333
Works with Optional TrueZONE Wireless Adapter* 333
M
M
OR
OR
Wired Directly to Equipment
2 Wires for Power or
Battery Only (no wires)
2 Wires for Power or
Battery Only (no wires)
Dual Powered - C Wire or Battery
(C wire or Wire Saver required to use RedLINK accessories)
RedLINK to Equipment Interface Module
RedLINK to TrueZONE Wireless Adapter
To Next Page
Loading...
