Honeywell TheraPro HR90 - Selecting the adapter; Mounting the radiator controller with adapter; Mounting the valve baseplate

4
Selecting the adapter
The radiator controller fits on common radiator valves
of the type M30 x 1.5. Adapters are required for some
valve types.
1. Check whether an adapter is required and, if
necessary, select the appropriate adapter.
Brand Illustration Adapter
Honeywell-
Braukmann,
MNG, Heimeier,
Oventrop valves
M30 x 1.5
Not
required
Danfoss RA Supplied
Danfoss RAV
Danfoss RAVL
2. Slide the adapter onto the radiator valve and turn it
until you feel it click into place.
3. If necessary, screw the adapter tight with a screw.
Mounting the valve baseplate
1a
1b
1. Separate the valve baseplate from the radiator
controller. To do so, push the slide towards .
3.
2.
2. Turn the adjustment dial of the valve baseplate
counter-clockwise until it stops.
3. Put the valve baseplate onto the radiator valve or the
adapter and tighten by hand (without tools!).
Mounting the radiator controller
2.
3.
1.
1. Ensure that the slide on the radiator controller is in the
open position.
2. Put the radiator controller onto the valve baseplate
so that the indentation latches in and is no longer
visible.
3. Lock the radiator controller in the end position. To do
so, push the slide towards .
After approx. 1 minute
cycl
(self-test) is displayed.
Afterwards the radiator controller changes to
automatic mode.
i
The radiator controller only operates if it is locked
correctly in the end position.
FINISHED! – After mounting, the radiator controller
operates immediately in the factory setting (standard
time program), see Section 5.