Honeywell VISTA-128BP - Changing a Master, Manager, or Operator Code; Adding an RF Key to an Existing User; Deleting a Master, Manager, or Operator Code; Exiting the User Edit Mode

VISTA-128BP/VISTA-250BP Installation and Setup Guide
9-4
PROMPT EXPLANATION
XMT USER DATA
1 = YES 0 = NO
If the user number is from 001-050 this appears. Answer YES (1) to have the system send the user’s attributes
to all the other control panels that are “linked” to this control. If you answer NO (0), the system displays the
following prompt on the next page.
INDV USER PGM
1 = YES 0 = NO
Answer YES (1) to link to another control panel and manually enter the user into partition(s) in that control
panel. If you answer NO (0), the system scrolls through each partition displaying a summary of the user’s
attributes in each partition (see next prompt).
Part. 1 A0* WHSE
User 003 Auth=3G.
Note that the “G” following the authority level indicates that the global arm feature is enabled for this user in the
displayed partition, and that the period at the end of the second line indicates Open/Close reporting is enabled
for this user in the displayed partition. The “T” indicates the partition from which the user may be changed or
deleted.
Changing a Master, Manager, or Operator Code
Enter Installer Code
*
+ [8] + new user no. (002-250) + new user’s code
*
Or Master or Manager Code, but the code must be a higher level of authority than the code being changed (e.g. a
Manager Code can add an Operator-level Code, but cannot add a Master or another Manager Code).
NOTE: The VISTA-128BP allows only 150 user codes.
PROMPT EXPLANATION
User Number = 003
NEW USER?
The system detects that the user number is already assigned, and prompts if this is a new user.
Press 0 (NO).
The system then confirms that the change is allowed based on authorization level.
Adding an RF Key to an Existing User
To add an RF key to an existing user, or to change a user’s global arm option, first delete that user’s code, then re-add
the user code as described in the “Adding a Master, Manager, or Operator Code” paragraph.
Deleting a Master, Manager, or Operator Code
Enter your code
*
+ [8] + new user no. (002-150) + your code again
*
Or Master or Manager Code, but the code must be a higher level of authority than the code being changed (e.g. a
Manager Code can add an Operator-level Code, but cannot add a Master or another Manager Code).
NOTE: The VISTA-128BP allows only 150 user codes.
PROMPT EXPLANATION
OK TO DELETE 003?
0=NO 1=YES
The system prompts to confirm that you want to delete this user. Press 0 (NO) or 1 (YES).
If you answered “yes,” that user’s code is removed from all partitions to which it was assigned, and all
authorization levels and other information about that user are deleted. Note that a user can be deleted only by
a user with a higher authority level. A user cannot delete himself.
A user code can be deleted only from the partition through which it was entered. If an attempt is made
to delete from another partition, the message “User [XXX] Not Deleted” is displayed.
Exiting the User Edit Mode
Press either [✴] or [#], or don’t press any key for 10 seconds.
WWW.DIYALARMFORUM.COM
WWW.DIYALARMFORUM.COM