Section 5 – Data Field Descriptions
5-15
FIELD
TITLE and DATA ENTRIES EXPLANATION
2*38
Pager 1 Partition Enable
0 = disable
1 = enable
This field has eight entries, one for each partition. If enabled, the system sends
messages to Pager 1 for the partition(s).
2*39
Pager 1 Trigger Event Enables
0 = disable
1 = enable
This field has five entries as follows: Alarm, Trouble, Bypass, Open/Close,
System.
If enabled, the system sends a signal to the pager.
2*40
Pager 2 Phone Number
Enter 0-9; #11 for *, #12 for #, #13 for a 2-
second pause.
Enter the paging service phone number for Pager 2. Enter up to 17 digits. Do
not fill unused spaces.
2*41
Pager 2 ID Number
Enter 0-9
Enter the Pager ID number for Pager 2. Enter up to 10 digits.
2*42
Pager 2 Format
0 = numeric
1 = ID
2 = alphanumeric
Enter the pager format for Pager 2.
2*43
Pager 2 Delay 1
000-060 seconds.
This delay occurs after the phone number is dialed and before the pager ID is
sent, giving the pager system time to answer the phone call.
NOTE: Program only if using numeric format.
2*44
Pager 2 Delay 2
000-060 seconds.
This delay occurs after the pager ID is sent and before the event information is
sent.
NOTE: Program only if using numeric format.
2*45
Pager 2 Partition Enable
0 = disable
1 = enable
This field has eight entries, one for each partition. If enabled, the system sends
messages to Pager 2 for the partition(s).
2*46
Pager 2 Trigger Event Enables
0 = disable
1 = enable
This field has five entries as follows: Alarm, Trouble, Bypass, Open/Close,
System.
If enabled, the system sends a signal to the pager.
2*47
Pager 3 Phone Number
Enter 0-9; #11 for *, #12 for #, #13 for a 2-
second pause.
Enter the paging service phone number for Pager 3. Enter up to 17 digits. Do
not fill unused spaces.
2*48
Pager 3 ID Number
Enter 0-9
Enter the Pager ID number for Pager 3. Enter up to 10 digits.
2*49
Pager 3 Format
0 = numeric
1 = ID
2 = alphanumeric
Enter the pager format for Pager 3.
2*50
Pager 3 Delay 1
000-060 seconds.
This delay occurs after the phone number is dialed and before the pager ID is
sent, giving the pager system time to answer the phone call.
NOTE: Program only if using numeric format.
2*51
Pager 3 Delay 2
000-060 seconds.
This delay occurs after the pager ID is sent and before the event information is
sent.
NOTE: Program only if using numeric format.
WWW.DIYALARMFORUM.COM
WWW.DIYALARMFORUM.COM
To Next Page
Loading...
