Section 5 – Data Field Descriptions
5-17
FIELD
TITLE and DATA ENTRIES EXPLANATION
2*66
Pager 5 Partition Enable
0 = disable
1 = enable
This field has eight entries, one for each partition. If enabled, the system sends
messages to Pager 5 for the partition(s).
2*67
Pager 5 Trigger Event Enables
0 = disable
1 = enable
This field has five entries as follows: Alarm, Trouble, Bypass, Open/Close,
System.
If enabled, the system sends a signal to the pager.
2*68
Pager 6 Phone Number
Enter 0-9; #11 for *, #12 for #, #13 for a 2-
second pause.
Enter the paging service phone number for Pager 6. Enter up to 17 digits. Do
not fill unused spaces.
2*69
Pager 6 ID Number
Enter 0-9
Enter the Pager ID number for Pager 6. Enter up to 10 digits.
2*70
Pager 6 Format
0 = numeric
1 = ID
2 = alphanumeric
Enter the pager format for Pager 6.
2*71
Pager 6 Delay 1
000-060 seconds.
This delay occurs after the phone number is dialed and before the pager ID is
sent, giving the pager system time to answer the phone call.
NOTE: Program only if using numeric format.
2*72
Pager 6 Delay 2
000-060 seconds.
This delay occurs after the pager ID is sent and before the event information is
sent.
NOTE: Program only if using numeric format.
2*73
Pager 6 Partition Enable
0 = disable
1 = enable
This field has eight entries, one for each partition. If enabled, the system sends
messages to Pager 6 for the partition(s).
2*74
Pager 6 Trigger Event Enables
0 = disable
1 = enable
This field has five entries as follows: Alarm, Trouble, Bypass, Open/Close,
System.
If enabled, the system sends a signal to the pager.
2*75
Pager 7 Phone Number
Enter 0-9; #11 for *, #12 for #, #13 for a 2-
second pause.
Enter the paging service phone number for Pager 7. Enter up to 17 digits. Do
not fill unused spaces.
2*76
Pager 7 ID Number
Enter 0-9
Enter the Pager ID number for Pager 7. Enter up to 10 digits.
2*77
Pager 7 Format
0 = numeric
1 = ID
2 = alphanumeric
Enter the pager format for Pager 7.
2*78
Pager 7 Delay 1
000-060 seconds.
This delay occurs after the phone number is dialed and before the pager ID is
sent, giving the pager system time to answer the phone call.
NOTE: Program only if using numeric format.
2*79
Pager 7 Delay 2
000-060 seconds.
This delay occurs after the pager ID is sent and before the event information is
sent.
NOTE: Program only if using numeric format.
2*80
Pager 7 Partition Enable
0 = disable
1 = enable
This field has eight entries, one for each partition. If enabled, the system sends
messages to Pager 7 for the partition(s).
WWW.DIYALARMFORUM.COM
WWW.DIYALARMFORUM.COM
To Next Page
Loading...
