Honeywell VISTA-128BP - Page 90

VISTA-128BP/VISTA-250BP Installation and Setup Guide
6-8
1. Enter the schedule number (01-20) and time
window number (01-20), and note the day of the
week the action is desired.
2. Enter the code for the desired action and
action specifier. The action codes represent the
events that are to take place when the scheduled
time is reached. Each action also requires an
action specifier, which defines what the action will
affect (relay, relay group, partition, zone list, user
group). The action specifier varies, depending on
the type of action selected.
The following is a list of the Action Codes (desired
actions) used when programming Time-Driven
events. Note that these codes are independent of
the relay codes programmed during Output
Programming in the #93 Menu Mode.
Relay Commands
Action Code Action Action Specifier
01 Relay On Relay #
02 Relay Off Relay #
03 Relay Close for 2 seconds Relay #
04
Relay Close XX minutes (set
in field 1*74)
Relay #
05
Relay Close YY seconds (set
in field 1*75)
Relay #
06 Relay Group On Relay Group #
07 Relay Group Off Relay Group #
08
Relay Group Close for 2
seconds
Relay Group #
09
Relay Group Close XX
minutes (set in field 1*74)
Relay Group #
10
Relay Group Close YY
seconds (set in field 1*75)
Relay Group #
Arm/Disarm Commands
Action Code Action Action Specifier
20 Arm-STAY Partition(s)
21 Arm AWAY Partition(s)
22 Disarm Partition(s)
23
Force Arm STAY (Auto-
bypass faulted zns)
Partition(s)
24
Force Arm AWAY (Auto-
bypass faulted zns)
Partition(s)
25 Arm INSTANT Partition(s)
26 Arm MAXIMUM Partition(s)
• The auto-arm warning (field 2*06) applies
when using Time-Driven events to auto-arm.
• Temporary schedules do not override an
auto-arming or auto-disarming programmed
in Time-Driven events.
• The auto-arming window cannot be
extended using the Installer Code + #82
Mode.
Bypass Commands
Action Code Action Action Specifier
30 Auto bypass – Zone list Zone list #
31 Auto unbypass – Zone list Zone list #
Open/Close Windows
Action Code Action Action Specifier
40
Enable Opening Window by
partition
Partition(s)
41
Enable Closing Window by
partition
Partition(s)
42
Enable Access Window for
access group
Access Group
Access Control Commands
Action Code Action Action Specifier
55 Access Point Grant Access Point #
56
Access Point Grant with
Override
Access Point #
57 Access Point Protect Access Point #
58 Access Point Bypass Access Point #
59 Access Point Lock Access Point #
60 Access Point Exit Access Point #
61 Access Point Group Grant Group #
62
Access Point Group Grant
with Override
Group #
63 Access Point Group Protect Group #
64 Access Point Group Bypass Group #
65 Access Point Group Lock Group #
66 Access Point Group Exit Group #
67 Access Point Partition Grant Partition #
68
Access Point Partition Grant
with Override
Partition #
69
Access Point Protect by
Partition
Partition #
70
Access Point Bypass by
Partition
Partition #
71 Access Point Lock by Partition Partition #
72 Access Point Exit by Partition Partition #
73 Access Point Trigger On Trigger #
74 Access Point Trigger Off Trigger #
77 Access Point Group Enable Group #
78 Access Point Group Disable Group #
WWW.DIYALARMFORUM.COM
WWW.DIYALARMFORUM.COM