33-00235 2
Wallplate Installation
1. Separate wallplate from thermostat.
2. Mount wallplate as shown below.
CAUTION: ELECTRICAL HAZARD
Can cause electric shock or equipment damage. Disconnect power supply before
beginning installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not
place the old control in the trash.
Drill 3/16" holes for drywall. Drill 7/32" holes for plaster.
Wall
anchors
Wallplate
Wire hole
Mounting
screws
Wallplate
Back of
Thermostat
To Next Page
Loading...
