7
2.5 Separating DT92E from its Mounting Plate (if required)
DT92E can be mounted (a) directly on a wall, or (b) on the optional table stand provided.
Wall mounting is recommended as it ensures a position of high signal strength can be maintained.
If the DT92E requires to be separated from its mounting plate, follow the simple steps shown below.
a. For wall mounting, install the mounting plate first, then follow
steps 1, 2 and 3 to hinge the front piece on, as shown in the
diagrams.
b. If the optional table stand is to be used, first assemble the two
pieces together as shown. Next follow steps 1, 2 and 3 to hinge
the DT92E front piece onto its mounting plate, and mount the unit
onto the table stand.
1
2
= N
o
6
3
2.4 Mounting DT92E
2
1
3
To Next Page
Loading...
