Applicat
ion
Wire sensor polarity
reversed!
Reconfirm boundaries?
The perimeter wire is set
in the opposite terminal
of the charging station.
The perimeter wire is set
wrong which cannot be
detected by the mower.
Unable to leave !
The mower is in trouble to
get through the working
area.
There are obstacles on
the path !
Out !
The mower is in trouble with
some obstacles on the path.
The mower is not in the
boundaries.
Boundary inspection time
out !
Abnormal power loss !
The mower impacting the
obstacles causes the walk
time out during the
recharging procedure.
The battery of the mower
is losing power.
Press the “Reset” button. Reset the
perimeter wire.See chapter “Encircling
obstacles” for details.
Press the “Confirm” button. Reset the
perimeter wire.See chapter “Encircling
obstacles” for details.
Press the “Reset” button. Stop the
mower and move the mower into the
working area , restart it.
Press the “Reset” button. Move the
obstacles from the recharging path.
Press the “Reset” button. Recharge
the mower.
Press the “Reset” button. Check if
there are any bumps or potholes.
DO NOT allow the mower mowing
there again before making them flat.
Press the “Reset” button. Move the
obstacles from the path.
22
ENEN
Original instructions
To Next Page
Loading...