Maintenance and Storage
DO NOT run any live mains cables in the working area. If a mains cable
becomes entangled in the robotic mower it must be isolated before any
attempt to remove it.
Ensure the correct installation of the charging station and boundary wire
as instructed in this manual.
Before each mowing session, check that all parts of the mower can function
normally. DO NOT use the lawn mower if the outer casing is damaged. The
blade may accidently cut you or you may be injured by debris thrown off
by the blades.
Avoid mowing in bad weather conditions especially when there is a risk of
lightning,heavy rain or snow. It is recommended to mow in dry weather.
DO NOT operate the machine when barefoot or wearing open sandals. Always
wear substantial footwear and long trousers.
Warning signs shall be placed around the work area if the product is used in
public areas. The signs shall have the following text: Warning! Automatic lawn
mower! Keep away.
Operate the machine in a suitable ambient temperature to avoid that low/high
temperatures decrease mower performance and even lead to accidents.
Regularly check the machine to keep all nuts, bolts, and screws tight , be
sure of the machine is in safe working condition.
Replace worn or damaged parts for safety. Ensure that the replacement is
the matching type.
DO NOT place anything on the mower or the charging station.
DO NOT modify this product. Unauthorized modifications may impair the
safety of your product and may result in increased noise and vibration.
Ensure that batteries are charged using the correct charger recommended
by the manufacturer. Improper use may cause electric shock, overheating,
or leakage of corrosive liquid.
4
Unless damaged by hard obstacles, these blades can last for up to five
Weekly inspection of the blades and the fixing screws is advised. Note
When the first side becomes bl unt, loosen the fixing screw and the blad
A set of spare blades is included with the Robotic Mower. More blades c
To ensure you get the best performance from your machine, always repla
Should your machine need a software update, contact our customer servi
• Check that the boundary wire in front and underneath the charger is i
• Check that the docking station's position is suitable as explained i
Robotic Mower runs in circles while mowing or while following boundary
• Verify that no power cable runs parallel and in close proximity the bou
• If a neighbor has a similar Robotic Mower, the signals may interfere.
• Grass may be too high. Try increasing the cutting hei
ght, or mow the l
Mower remains at or returns to docking station when pressing START but
• Check if the mower has already completed the programmed working time
The mobile displays a fault code when unexpected events occurs. Solve
Owner’s Manual
Class III appliance
Waste electrical products must not be disposed of with
exist. Check with your local authorities or retailer for rec
Owner’s Manual
Do not wash the machine with a high pressure washer
Class III appliance
Waste electrical products must not be disposed of with househ
exist. Check with your local authorities or retailer for recycling a
Waste ele ctrical pr oduct s must not be disposed of
exis t . Ch eck wit h your l ocal a ut horiti es or ret aile
Do not disp ose of batterie s. Ret urn exhaust ed bat t er i es t
Waste ele ctrical pr oduct s must not be disposed of wit h h
exis t . Ch eck wit h your l ocal a ut horiti es or ret aile r f or
Owner’s Manual
Class III appliance
Waste electrical products must not be disposed of with household waste.
exist. Check with your local authorities or retailer for recycling advice.
EN
Waste electrical products must not be disposed of with
exist. Check with your local authorities or retailer for rec
Waste electrical products must not be disposed of with househ
exist. Check with your local authorities or retailer for recycling a
Waste electrical products must not be disposed of with household waste.
Original instructions
To Next Page
Loading...