Hoover FloorMate Edge User Guide

Push switch to turn machine on, push switch again to
turn machine off.
Step on handle release pedal to recline machine.
Cleaning the filter
Using your machine
OPERATION
6
Rinse under water to remove
debris (max. 40°C) and leave
for at least 24 hours or until
fully dry before replacing in
the machine.
After each use clean the water tank filter. Pull open the clean
water tank lid, gently remove filter.
The mode selector allows you to choose DRY mode or WASH mode.
To wet clean with spinscrub brushes turned on, turn the dial
to the WASH position.
DRY mode raises the Spinscrub brushes off the floor and also stops them
spinning to allow the water to be picked up.
To move your machine from
room to room, with the
handle in the upright
position and tilt the machine
back on the rear wheels.

Hoover FloorMate Edge Specifications

General

Brand	Hoover
Model	FloorMate Edge
Category	Vacuum Cleaner
Language	English