EasyManua.ls Logo

Hoover HWP 49AMBC7/1-S - User Manual

Hoover HWP 49AMBC7/1-S
136 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
IT
EN
ES
FR
DE

Questions and Answers

  • C
    Carrie SmithAug 14, 2025
    Why my Hoover HWP 49AMBC7/1-S Washer does not start?
    • W
      William JohnsonAug 14, 2025
      If your Hoover Washer isn't starting, several factors could be at play. First, ensure the appliance is correctly plugged into a working power socket and that the power is switched on. Test the socket with another device, like a lamp, to confirm it's functional. Also, the door may not be correctly closed; try opening and closing it firmly. Check that you've selected the desired program and pressed the start button. Finally, verify that the washer isn't in pause or time delay mode.
  • T
    tiffanythomasAug 17, 2025
    Why is my Hoover HWP 49AMBC7/1-S Washer leaking water on the floor?
    • J
      Joseph JohnsonAug 17, 2025
      If you notice water leaking from your Hoover Washer, it could stem from a few sources. It might be leaking from the seal between the tap, supply hose, and fill valve; if so, replace the seal and tighten the hose connections correctly. Also, ensure that the front filter is correctly closed.
  • R
    reynoldscurtisAug 21, 2025
    What to do if my Hoover HWP 49AMBC7/1-S Washer does not spin?
    • C
      Cameron LeonardAug 21, 2025
      If your Hoover Washer isn't spinning, there are a few potential reasons. First, try removing the load, detangling it, reloading it, and restarting the spin program. The water might not have completely drained, so wait a few minutes. Also, some models have a 'no spin' function, so ensure that it is not selected. Check the selected options and their impact on the spin cycle. Excessive detergent can also prevent spinning, so ensure you're using the correct amount.
  • A
    Amanda MartinAug 25, 2025
    What to do if my Hoover HWP 49AMBC7/1-S shows error E7?
    • E
      evanscatherineAug 26, 2025
      If your Hoover Washer displays error code E7 or flashes the LEDs 7 times, make sure the door is correctly closed and that no clothing is preventing it from fully closing. If the door is locked, switch off and unplug the washing machine, wait 2-3 minutes, and then try reopening the door.
  • L
    Laura MillerAug 29, 2025
    How to reduce vibration of my Hoover HWP 49AMBC7/1-S Washer?
    • K
      Katie RhodesAug 29, 2025
      If you're experiencing strong vibrations or noises during the spin cycle of your Hoover Washer, it could be due to a couple of things. The washing machine might not be fully leveled; adjust the feet as needed. Also, ensure that the transport screws, rubber bungs, and spacer tubes were removed during installation.
  • D
    Donald RobertsSep 1, 2025
    What does error E3 mean on my Hoover Washer?
    • P
      Patrick MartinSep 2, 2025
      If your Hoover Washer displays error code E3 or the LEDs flash 3 times, check that the filter isn't clogged and that there are no foreign objects inside the filter compartment obstructing water flow. Also, ensure the drain hose isn't bent, kinked, or trapped. Finally, verify that your home drainage system isn't blocked, allowing water to flow freely. Try draining water in the sink to check.
  • M
    Ms. Brenda BryanSep 5, 2025
    What does error E2 mean on my Hoover HWP 49AMBC7/1-S?
    • B
      Brandon JonesSep 5, 2025
      If your Hoover Washer displays error code E2 or the LEDs flash twice, make sure the water supply tap is open and the supply hose isn’t bent, kinked, or trapped. Ensure the drain pipe is at the correct height. Close the water supply tap, unscrew the filler hose from the back, and check that the anti-sand filter is clean and not blocked. Also, check that the filter is not clogged and that there are no foreign bodies inside the filter compartment.
  • K
    Kimberly JenningsSep 9, 2025
    What does error E4 mean on my Hoover HWP 49AMBC7/1-S Washer?
    • J
      james35Sep 9, 2025
      If your Hoover Washer displays error code E4 or flashes the LEDs 4 times, ensure you're using the correct amount of detergent and that it's designed for use in a washing machine.

Hoover HWP 49AMBC7/1-S Specifications

General IconGeneral
TypeFront Load
Capacity9 kg
Spin Speed1400 rpm
Energy RatingA+++
Programs15
Dimensions (HxWxD)85 x 60 x 54 cm
Energy Efficiency ClassA+++
ColorWhite
Water Consumption49 L

Related product manuals