3. Hold open the Hose Solution Port door.
4. Plug the Hose Solution Tube connector firmly into the Hose Solution Port.
If additional cleaning is necessary, wait until the upholstery is completely dry before using the tool again.
Empty Dirty Water Tank when the motor sound becomes higher pitched and there is a loss in suction (see
“Automatic Shutoff”).
When finished cleaning, follow “After Cleaning” and “After Using Tool” instructions.
How to Remove Hose
1. Disconnect Hose Solution Tube from Hose Solution Port by pulling up firmly. Do not pull on tube, this may
cause damage. Port door will automatically close.
To Next Page
Loading...
