EasyManuals Logo

Hoover Power Scrub Elite User Manual

Hoover Power Scrub Elite
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
release air and fluid.
4. Replace hose and tools in the Mesh Tool Storage Bag.
CAUTION
Always turn off appliance before connecting or disconnecting hose.
Cleaning Carpeted Stairs
1. Read “Before You Begin Cleaning” instructions.
2. Attach hose and solution tube as instructed.
3. Place handle in upright position. SpinScrub® brushes will not rotate while handle is in upright position.
4. Fill Clean Water Tank according to instructions.
5. Fill Solution Tank with HOOVER solution according to instructions.
6. Attach tool to end of hose.
7. Dry hands and plug cleaner into a properly grounded outlet.
8. Set Wash/Rinse Selection to WASH. Turn cleaner ON.
9. Pre-spray the carpeted stair by holding the tool about one inch above the carpet and push it forward while
pressing the trigger (Fig. C).
10. Position tool against the riser and slightly press it into carpet pile. Press the trigger and pull the tool slowly
over the carpet. Release trigger at end of stroke.
11. Lift tool, and position it against riser. Pull tool slowly over carpet without pressing trigger (Fig. D).
12. Overlap strokes by 1/2 inch to help prevent streaking.
13. It is best to alternate wet and dry strokes as described in steps.
CAUTION
Use extra care when cleaning on stairs. To avoid personal injury or damage, and to prevent the cleaner from
falling, always place cleaner at bottom of stairs or on floor. Do not place cleaner on stairs or furniture, as it
may result in injury or damage.
9-12. End with more dry strokes to aid in faster drying of carpet.
14. To avoid saturating carpet, do not use more than 4 wet strokes over any one area. Always end with dry
strokes.
15. If additional cleaning is necessary, wait until the carpet is completely dry before using the tool again.
16. Empty Dirty Water Tank when the motor sound becomes higher pitched and there is a loss in suction. You will
also see the float rise and shut off suction at the same time.
17. When finished cleaning, follow “After Cleaning” and “After Using Tool” instructions.

Other manuals for Hoover Power Scrub Elite

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hoover Power Scrub Elite and is the answer not in the manual?

Hoover Power Scrub Elite Specifications

General IconGeneral
TypeCarpet Washer
Brush SystemSpinScrub Brush System
Heated CleaningYes
Cord Length20 ft
Warranty2-year limited warranty
Power10 Amps
ColorRed
Cleaning ModesDeep Clean, Quick Clean
Included ToolsUpholstery Tool
Tank Capacity1.25 gallons

Related product manuals