Hoover Power Scrub Elite User Manual

Blown fuse or tripped breaker.
Replace fuse or reset breaker in
home.
Fuse in cleaner blown. Take to service center.
Low suction.
Dirty Water Tank full/automatic shut
off engaged.
Remove and empty Dirty Water Tank.
See “How to Empty”.
Blockage in tool on end of hose. Remove tool and clear blockage.
Dirty Water Tank lid not on correctly.
Make sure lid is on securely See “How
to Use”.
Dirty Water Tank Debris Filter
Clogged.
See “How to Clean”.
Blockage in nozzle. See “How to Clean”.
Recovery Tank not properly secured.
Replace Recovery Tank and secure
recovery tank latch.
Hose nozzle stops spraying liquid
during use.
Clean Water Tank or Degergent
Container is empty.
Turn off cleaner and fill Clean Water
Tank and Detergent Container.
Loose connection to solution port on
foot of cleaner.
Check for secure connection to
solution port on foot of cleaner.
Hose nozzle will not spray after filling
the Clean Water Tank or Detergent
Container.
Air is trapped in the pump and hose.
Turn on the cleaner. If hose does not
spray, prime the pump by lowering
the hose down to the floor and hold
the trigger for up to 1 minute.
Hold trigger to floor and squeeze
trigger.
Aim downward and squeeze trigger.

Hoover Power Scrub Elite Specifications

General

Type	Carpet Washer
Brush System	SpinScrub Brush System
Heated Cleaning	Yes
Cord Length	20 ft
Warranty	2-year limited warranty
Power	10 Amps
Color	Red
Cleaning Modes	Deep Clean, Quick Clean
Included Tools	Upholstery Tool
Tank Capacity	1.25 gallons