10
Keep your Rewind Running Properly: Cleaning Rinsable Filter
WARNING
To reduce the risk of personal
injury - Unplug before
cleaning or
servicing. Do not use vacuum
without dirt
cup or filters in place.
WARNING
Very fine materials,
such as face powder
or cornstarch, may seal the
filter and cause a reduction
in performance. When using
the vacuum for this type of
dust,
empty the cup and
clean the filters often.
IMPORTANT
Allow filter to dry
completely before
replacing. Dry filter on edge
so air circulates
on both sides of the
filter. This will take
at least 24 hours.
What to Buy:
Rinsable Filter
When used and
maintained properly,
your Rinsable Filter
should not need
replacement within
the warranty period.
If desired, additional
filter is available at Hoover.
com or call 1-800-944-
9200. Ask for Hoover
®
Part
No. 304087001
Rinse for 2 minutes
in clear warm water;
dry for
a minimum of
24 hours.
Replace the filter, tab
side out.
Twist lid securely until
it clicks.
Remove the dirt cup.
Twist the lid open. Pull
tab to remove the filter.
3
2
1
To Next Page
Loading...
Need help?
General
