Hoover Rewind - Assembly; Getting Started

3
Place Crevice Tool
into wand then slide
into storage
area. Place
the Dusting
Brush on the
other side.
Remove handle screw
and insert handle.
4
32
1
5
Getting Started with your Rewind
NOTE: Actual model may vary from images shown.
Insert handle screw
and tighten with a
Phillips screwdriver.
Then tighten
2 small screws
in the front
lower handle.
Place bottom
of dirt cup in
first and pivot
into place.
It’ll click.
Secure Turbo
tool here.