If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water,
take it to a service center prior to continued use.
A WARNINGA
To reduce the risk of persona! injury - Unplug before cleaning or servicing.
POSSIBLECAUSE POSSIBLESOLUTIONPROBLEM
Vacuum won't
run
Vacuum won't
pick up
or
Low suction
Dust escaping
from vacuum
Brushroll will
not turn
2. No voltage in wall plug.
4. Thermal Protector activated.
2. Check fuse or breaker in home.
4. Unplug and allow vacuum to cool for 30min.
(This will reset the thermal protector)
1. Rinsable filter and/or filter 1.Clean rinsable filter and or filter made
made with HEPA media is dirty, with HEPA media - Pg.10
pt
3. Brushroll and/or hose
clogged.
5. Valve is in the wrong mode
selection.
2. Dirt cup not installed correctly.
4, Rinsable and/or filter made
with HEPA media not installed
completely.
2. Brushroll is clogged.
3. Check hose. Check brushroll - Pg.11.
5. Change valve to the appropriate mode.
2. Review dirt cup removal & replacement -
Pg. 9.
4, Review filter removal and cleaning - Pg. 10,
2. Clear/remove debris from brushroll - pg 11
13
To Next Page
Loading...
Need help?
General
Weight and Dimensions
