EasyManuals Logo

Hoover WindTunnel User Manual

Hoover WindTunnel
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
Stair cleaning
Stand on one end of rug and move
cleaner toward other end or edge. Before
reaching edge, push down on handle.
This will lift up the nozzle (front of cleaner)
as shown and will prevent rug from
clinging to cleaner. Continue to lift up
nozzle so that when you have reached
the edge, it is completely off the rug.
Move cleaner back to start again, lower
nozzle, and use only forward strokes.
Cleaning lightweight
flexible rugs
Edge cleaning
Special edge groomers are provided on
both sides of the nozzle to remove dirt in
carpet near baseboards and furniture.
Guide either side of nozzle parallel to
edge of carpet or furniture.
A stair cleaning handle has been de-
signed for ease in using your cleaner on
stairs. With handle in operating position,
place fingers under edge of stair cleaning
handle and guide cleaner with other hand
on upper handle.
As an alternative, you may use the hose
and furniture nozzle for stair cleaning.
Clean from bottom to top.
When using cleaning tools, the agitator
will continue to rotate.
CAUTION: To avoid personal injury or
unnecessary wear to carpet, and to
prevent the cleaner from falling, always
place it at bottom of stairs.
Cleaning tools
Tools allow for cleaning surfaces above
the floor and for reaching hard to clean
areas.
The cleaner is ready for tool use when
handle is in upright position.
CAUTION: Agitator continues to rotate
while cleaner handle is in upright
position. Avoid tipping cleaner or
setting it on furniture, fringed area
rugs or carpeted stairs during tool use.
A
B
2-14
Removing hose
When using cleaning tools, cleaner
handle should be in the upright
position. Also, turn cleaner OFF
before disconnecting and connecting
hose to hose tube (A).
To use hose, lift hose end as shown.
Lower cover (B) onto hose tube. When
you are finished cleaning with the tools,
be sure to lift cover from hose tube
and reposition hose end into tube.
How to clean tools
To clean the hose, wipe off dirt with a
cloth dampened in a mild detergent.
Rinse with a damp cloth.
Cleaning tools may be washed in warm
water with a detergent. Rinse and air dry
before using.
C
2-15
Select proper tool
C. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian blinds,
baseboards, shutters, and registers.
D. Furniture nozzle may be used for
upholstered furniture, draperies, mat-
tresses, clothing, automobile interiors,
and carpeted stairs.
E. Crevice tool* may be used in tight
spaces, corners and along edges in such
places as dresser drawers, upholstered
furniture, stairs and baseboards.
F. Crevice wand* may be used for the
same tasks as the crevice tool. It can also
D
E
G
F

Other manuals for Hoover WindTunnel

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hoover WindTunnel and is the answer not in the manual?

Hoover WindTunnel Specifications

General IconGeneral
TypeUpright
Bagged/BaglessBagless
Filter TypeHEPA
Power12 amps
FeaturesWindTunnel Technology
Dust Capacity1.5 liters
Height44 inches
Width13 inches
ColorBlue

Related product manuals